Electrical Safety Code Manual

In the case of the electrical industry, safety is critical and the codes and regulations that determine safe practices are both diverse and complicated. Employers, electricians, electrical system designers, inspectors, engineers, and architects must all comply with safety standards listed in the National Electrical Code, OSHA and NFPA 70E.

Electrical Safety Code Manual

System-on-Chip - SoC - IP

When a product has to be made small, the board real estate is limited or it has to be manufactured in large numbers.... SoC is the Answer. A Microprocessor evolved into a Microcontroller by packing many external chips into one chip. Now uC Card along with the other blocks like A-D, Port Drivers, Networking elements, Display Driver and other peripherals can be packed into one chip.

System on a chip

Induction Heating - Cooker Project

Single plate induction cooker demonstration board Uses ST7LITE09 and STGW40NC60WD (40 A, W series).

The design is entirely controlled by a simple ST7FLITE09Y0 8-bit microcontroller, which provides the PWM driving signals, communicates information to the user interface, and drives the fan and relay control to the plate feedback.

With Single Voltage Flash Memory, Data Eeprom, Adc, Timers, Spi Active - ST7LITE09Y0 8-Bit Mcu

SCADA - Supervisory Control and Data Acquisition

A Closed loop control system has a Sensor-Controller-Actuator. The Bimetal Thermostat has all the three in the Bimetal itself. The Sensor, the Relay Contact and the Intelligence. This is Process Control when implemented to control the temperature in a Bakery Oven.

This leads us to Sensors-Transmitter-Controller-Outputs-Actuators. Where each is an independent electronic/electrical component of an entire Process Control system. The Process could be Temperature, Pressure, Speed, or Level.

Pages